Krone EasyCut TS 320

Double tap to zoom



  • The ideal solution for smaller tractors – shifting weight off the rear axle
  • Light-pulling and compact machine with a sturdy V-Frame
  • Slewing gearbox for round and round work and on-the-spot turns
  • DuoGrip center-of-gravity Suspension
  • Convenient depth control from a crank handle


Are you looking for a powerful trailed mower without conditioner that works at a width of about 3.16 m? Then the Krone EasyCut TS 320 with DuoGrip center-of-gravity suspension is the machine for you. This mower stands out for an extremely low power input, maximum stability as well as a superior level of specification and operator comfort.

The trailed EasyCut TS 320 without conditioner impresses by its superior performance, very light draft and good ride qualities. Compared with a mounted mower, the trailed machine reduces the load on the tractor's rear axle and its hydraulics. As another plus, it offers a much lower transport height and hence better road safety. The transport position does not exceed 3.00 m.

The V-shaped frame of the EasyCut TS 320 model with side-mounted drawbar is robust and compact. Its generous ground clearance makes for plenty of vertical travel. Suspended in its centre of gravity and linkage controlled, the cutterbar swings back and up through a large angle avoiding obstacles, a design that ensures clean work also in undulating fields. The cutterbar is driven by a powerful right-angle gearbox which makes for a frictional connection and is arranged behind the inner top hat.

It takes just a minute to adjust the machine perfectly to the current conditions. The cutterbar’s ground pressure is set by tensioning the coil springs.

Equipped with side-mounted drawbar and pivoting gearbox, the unit cuts around any bend. The two-point headstock attaches to the height-adjustable link arms – although the floating drawbar has become the preferred choice of attachment in some countries.

The front curtain folds up to give convenient access to the discs for easy cleaning and blade replacement.

Running inline behind the tractor during road travel, EasyCut TS 320 does not exceed the statutory 3 m transport width, gives plenty of ground clearance and is approved to 40 km/h maximum speed. This is the machine to travel quickly between sites.


Sorry, currently there are no specs but check back with us later.